JUST ADDED–1983 Bobst SP 102E (completely updated)

Specifications

Elevated press

Continuous feed

Continuous delivery

Internal and external stripping

Front edge stripping

-              4 cutting chases

-              1 honeycomb chase (embossing)

-              3 x 5mm cutting plates

-              1 x 4mm compensation plate (for 1mm thin plates)

-              1 x 3mm compensation plate (for multi piece 1mm plates)

-              3 Meurer upper stripping frames

-              3 Bobst upper stripping frames

-              3 Bobst lower stripping frames

-              3 middle stripping frames (for female) with bars and clamps

-              1 set of used gripper bars

-              1 Preset stripping table

-             full set of delivery chains still in box

List of all repairs completed

• Rebuilt feeder head 2022
• Major delivery rebuilt 2022
• Replaced the main motor and drive with the Bobst AC motor and drive kit. Installation was done by Bobst 2013.
• Replaced the delivery pile motor with the most current Bobst upgrade 2015.
• New gripper bars with locking reset by Bobst technician 2014.
• New lower plate. Platen was re leveled by Bobst technician 2014.
• Rebuilt entire mechanism for the front trim removal device 2014.
• Rebuilt hydraulic pump unit 2014.
• Rebuilt entire mechanism for the sheet down holder in the infeed 2014.
• Rebuilt the side guide 2016.
• Rebuilt Becker feeder pump this 2016
• All electrical systems have been serviced in 2016.